For FG2.4.0 use left and middle mouse buttons to turn any switches left/right.
The 777 autopilot can be fully controlled using the 3D cockpit switches. Make sure the ACMP's are on when you want to use the center system on APU/Ground Power.Ī realistic Ram Air Turbine (RAT) and reserve system have yet to be modeled. When no engine is running, the APU (if running) and/or Ground Power (if connected and activated) provide power to the center system's ACMP's. It operates the landing gear actuation, nose & main gear steering, flaps & slats, flight controls and the reserve brake system. The Center system is powered by two ACMP's and supplemented by two on-demand air turbine-driven pumps (ADP).It operates flight controls, right thrust reverser operation and the normal brake system. The Right system is powered by by an EDP from the right engine and supplemented by an ACMP.It operates wing & tail flight controls (ailerons, elevators, rudder) and left thrust reverser operation. The Left hydraulic system is powered by an engine driven pump (EDP) and supplemented by two on-demand Electric motor pumps (ACMP).As in real life, the following behavior should be expected: The hydraulic systems can (and must) be fully controlled via the 3D cockpit switches on the overhead panel. The current Boeing 777 hydraulic system is basically working, it will be expanded in the future for more realistic behavior. You can help the wiki by expanding it.Įlectrical This section is a stub. Rudder Ratio, Yaw Damper and Turn CoordinatorĮngines This section is a stub. C*U Pitch Law and Trim Ref function with Flare Mode and Autotrim Roll Control Law with attitude holding and bank angle protection The fly-by-wire system has been simulated within the limitations of YAsim. The signals are sent electrically to the hydraulic actuators which move the control surfaces.
BOEING 777 COCKPIT INTERIOR SERIES
The Boeing 777 series are fly-by-wire aircraft and like all Boeing aircraft have yokes.
0 kommentar(er)
